Standard part · ISO 4017
M16 hex head screw ISO 4017 / DIN 933
All dimensions of the fully threaded M16 hex head screw: width across flats, head height, clearance hole and tap drill. And how to write it in your BOM so it doesn't get ordered twice.
Dimensions
M16 in mm
- Thread
- M16 × 2
- Width across flats s (ISO)
- 24
- Width across flats DIN 933
- 24
- Head height k
- 10
- Without full thread a
- 6
k is nominal; a is the maximum length under the head without full thread (3 × P).
Holes
Clearance hole and tap drill
- Clearance hole medium
- 17.5
- Clearance hole fine
- 17
- Tap drill
- 14
Clearance hole to ISO 273. The tap drill is for the tapped hole the screw goes into.
In your BOM
One notation per screw
Use the designation from the standard itself (standard, size × length, property class) and keep that notation throughout the BOM. For example:
ISO 4017 - M16 x 65 - 8.8
Common mistake: DIN 933 M16x65, ISO 4017 - M16 x 65 - 8.8 and Hex screw M16 x 65 are three lines in the BOM, while they are one part.
Lengths
Standard lengths per ISO 4017
- M16×30
- M16×35
- M16×40
- M16×45
- M16×50
- M16×55
- M16×60
- M16×65
- M16×70
- M16×80
- M16×90
- M16×100
- M16×110
- M16×120
- M16×130
- M16×140
- M16×150
- M16×160
The standard lists lengths from 2 × d to 10 × d, with a maximum of 200 mm. Which lengths are in stock differs per supplier.
Always put the property class in the description, for example 8.8 for steel or A2-70 for stainless steel.
Questions
Frequently asked questions about the M16
01 Which spanner fits an M16 hex head screw?
A 24 mm spanner (ISO 4017). For a screw to the old DIN 933 the width across flats is 24 mm.
02 What clearance hole do I drill for M16?
17.5 mm (ISO 273, medium). If the screw needs to sit more accurately, 17 mm (fine).
03 Which tap drill do I use for M16?
14 mm for coarse thread M16 × 2: roughly the nominal diameter minus the pitch.
04 How do I write an M16 hex head screw in my BOM?
With standard, size × length and property class, for example ISO 4017 - M16 x 65 - 8.8. Use the same notation everywhere, even if an older drawing still says DIN 933.
Checked against
- ISO 4017:2022, tabel 1 en 2 (inkijkexemplaar)
- Reyher: Technische Informationen (ISO 4017 ersetzt DIN 933)
- fasten.it: DIN 933 (1987)
- neue-physik.de: Durchgangslöcher (DIN EN 20273)
- Albany County Fasteners: clearance holes ISO 273
- Optimas: tapping sizes
Every dimension on this page was checked on 15 November 2026 against at least two of these sources.
For a critical application, always check the dimensions in the standard or with your supplier.
Is this screw in your BOM twice?
Put model, drawing and BOM side by side and see per position what doesn't match.