Standard part · ISO 4762
M12 socket head cap screw ISO 4762 / DIN 912
All dimensions of the M12 socket head cap screw in one place: head, socket, thread, clearance hole, counterbore and tap drill. And how to write it in your BOM so it doesn't get ordered twice.
Dimensions
M12 in mm
- Thread
- M12 × 1.75
- Head diameter dk
- 18
- Head height k
- 12
- Socket s
- 10
- Socket depth t
- 6
- Thread length b
- 36
dk and k are maximums, t is a minimum, b applies to long screws.
Holes
Clearance hole, counterbore and tap drill
- Clearance hole medium
- 13.5
- Clearance hole fine
- 13
- Counterbore ø
- 20
- Counterbore depth
- > 12
- Tap drill
- 10.2
Clearance hole to ISO 273, counterbore for the cylindrical head to DIN 974-1. Make the counterbore slightly deeper than the head height so the head sits fully inside.
In your BOM
One notation per screw
Use the designation from the standard itself (standard, size × length, property class) and keep that notation throughout the BOM. For example:
ISO 4762 - M12 x 50 - 8.8
Common mistake: DIN 912 M12x50, ISO 4762 - M12 x 50 - 8.8 and Socket screw M12 x 50 are three lines in the BOM, while they are one part.
Lengths
Commonly supplied lengths
- M12×20
- M12×25
- M12×30
- M12×35
- M12×40
- M12×45
- M12×50
- M12×60
- M12×70
- M12×80
- M12×100
- M12×120
Which lengths are in stock differs per supplier.
Property classes per ISO 4762: steel 8.8, 10.9 and 12.9; stainless A2-70 and A4-70.
Questions
Frequently asked questions about the M12
01 Which hex key fits an M12 socket head cap screw?
A 10 mm hex key. The socket is at least 6 mm deep.
02 What clearance hole do I drill for M12?
13.5 mm (ISO 273, medium). If the screw needs to sit more accurately, 13 mm (fine). To sink the head, use a counterbore of ø20 mm (DIN 974-1), slightly deeper than 12 mm.
03 Which tap drill do I use for M12?
10.2 mm for coarse thread M12 × 1.75: roughly the nominal diameter minus the pitch.
04 How do I write an M12 socket head cap screw in my BOM?
With standard, size × length and property class, for example ISO 4762 - M12 x 50 - 8.8. Use the same notation everywhere, even if an older drawing still says DIN 912.
Checked against
- ISO 4762:1997, tabel 1 (inkijkexemplaar)
- fasten.it: DIN EN ISO 4762:2004
- Reyher: Technische Informationen
- neue-physik.de: Durchgangslöcher (DIN EN 20273) en Senkungen (DIN 974-1)
- Albany County Fasteners: clearance holes ISO 273
- RUKO: Flachsenker DIN 373
- Strobel: Senkung en fase berekenen
- Optimas: tapping sizes
Every dimension on this page was checked on 15 November 2026 against at least two of these sources.
For a critical application, always check the dimensions in the standard or with your supplier.
Is this screw in your BOM twice?
Put model, drawing and BOM side by side and see per position what doesn't match.