Skip to content
BOMproof

Standard part · ISO 4762

M3 socket head cap screw ISO 4762 / DIN 912

All dimensions of the M3 socket head cap screw in one place: head, socket, thread, clearance hole, counterbore and tap drill. And how to write it in your BOM so it doesn't get ordered twice.

s 2.5dk 5.5k 3b 18lM3t 1.3

Dimensions

M3 in mm

Thread
M3 × 0.5
Head diameter dk
5.5
Head height k
3
Socket s
2.5
Socket depth t
1.3
Thread length b
18

dk and k are maximums, t is a minimum, b applies to long screws.

Holes

Clearance hole, counterbore and tap drill

Clearance hole medium
3.4
Clearance hole fine
3.2
Counterbore ø
6.5
Counterbore depth
> 3
Tap drill
2.5

Clearance hole to ISO 273, counterbore for the cylindrical head to DIN 974-1. Make the counterbore slightly deeper than the head height so the head sits fully inside.

In your BOM

One notation per screw

Use the designation from the standard itself (standard, size × length, property class) and keep that notation throughout the BOM. For example:

ISO 4762 - M3 x 12 - 8.8

Common mistake: DIN 912 M3x12, ISO 4762 - M3 x 12 - 8.8 and Socket screw M3 x 12 are three lines in the BOM, while they are one part.

Lengths

Commonly supplied lengths

  • M3×6
  • M3×8
  • M3×10
  • M3×12
  • M3×16
  • M3×20
  • M3×25
  • M3×30

Which lengths are in stock differs per supplier.

Property classes per ISO 4762: steel 8.8, 10.9 and 12.9; stainless A2-70 and A4-70.

Questions

Frequently asked questions about the M3

01 Which hex key fits an M3 socket head cap screw?

A 2.5 mm hex key. The socket is at least 1.3 mm deep.

02 What clearance hole do I drill for M3?

3.4 mm (ISO 273, medium). If the screw needs to sit more accurately, 3.2 mm (fine). To sink the head, use a counterbore of ø6.5 mm (DIN 974-1), slightly deeper than 3 mm.

03 Which tap drill do I use for M3?

2.5 mm for coarse thread M3 × 0.5: roughly the nominal diameter minus the pitch.

04 How do I write an M3 socket head cap screw in my BOM?

With standard, size × length and property class, for example ISO 4762 - M3 x 12 - 8.8. Use the same notation everywhere, even if an older drawing still says DIN 912.

Checked against

Every dimension on this page was checked on 15 November 2026 against at least two of these sources.

For a critical application, always check the dimensions in the standard or with your supplier.

Is this screw in your BOM twice?

Put model, drawing and BOM side by side and see per position what doesn't match.