Skip to content
BOMproof

Standard part · ISO 4032

Hex nut M24 ISO 4032 / DIN 934

All dimensions of the M24 hex nut: width across flats and height per ISO 4032 and DIN 934, the clearance hole for the bolt and which bolt goes with it. And how to put it in your BOM so it is not ordered twice.

s 36m 21.5M24

Dimensions

M24 in mm

Thread
M24 × 3
Width across flats s (ISO)
36
Width across flats DIN 934
36
Height m (ISO)
21.5
Height DIN 934
19

m is the maximum height. DIN 934 is withdrawn; its dimensions are listed because you still find them in older BOMs.

Note: the DIN 934 nut M24 is 19 mm high, the ISO 4032 nut 21.5 mm. The spanner is the same, but they are two different items. Pick one in your BOM.

Holes

Clearance hole for the bolt

Clearance hole medium
26
Clearance hole fine
25

Clearance hole to ISO 273 for the bolt you tighten with this nut.

In your BOM

One notation per nut

Use the designation from the standard itself (standard, size, property class) and keep that notation throughout the BOM. For example:

ISO 4032 - M24 - 8

Common mistake: ISO4032 M24, ISO 4032 - M24 - 8 and Nut M24 are three lines in the BOM, while they are one part.

Matching bolt

Bolts for the M24

Match the property class of the nut to the bolt: an 8.8 bolt takes a class 8 nut, a higher class is fine as well. For stainless steel, for example A2-70.

Questions

Frequently asked questions about the M24

01 Which spanner fits an M24 hex nut?

A 36 mm spanner (ISO 4032). For a nut to the old DIN 934 the width across flats is 36 mm.

02 How high is an M24 hex nut?

At most 21.5 mm to ISO 4032. A nut to the old DIN 934 is at most 19 mm high.

03 Which nut goes with an M24 8.8 bolt?

An M24 nut of property class 8, for example ISO 4032 - M24 - 8. A higher class is fine as well, a lower one is not.

04 How do I put an M24 hex nut in my BOM?

With standard, size and property class, for example ISO 4032 - M24 - 8. Use the same notation everywhere. If an older drawing still says DIN 934, choose deliberately: from M5 the ISO nut is higher, and for M10 and M12 the width across flats differs too.

Checked against

Every dimension on this page was checked on 15 November 2026 against at least two of these sources.

For a critical application, always check the dimensions in the standard or with your supplier.

Is this nut in your BOM twice?

Put model, drawing and BOM side by side and see per position what doesn't match.