Skip to content
BOMproof

Standard part · ISO 4032

Hex nut M12 ISO 4032 / DIN 934

All dimensions of the M12 hex nut: width across flats and height per ISO 4032 and DIN 934, the clearance hole for the bolt and which bolt goes with it. And how to put it in your BOM so it is not ordered twice.

s 18m 10.8M12

Dimensions

M12 in mm

Thread
M12 × 1.75
Width across flats s (ISO)
18
Width across flats DIN 934
19
Height m (ISO)
10.8
Height DIN 934
10

m is the maximum height. DIN 934 is withdrawn; its dimensions are listed because you still find them in older BOMs.

Note: for DIN 934 the M12 is 19 mm across flats and 10 mm high, for ISO 4032 18 mm and 10.8 mm. If both are in your BOM, they are two different parts and the shop floor needs two spanners.

Holes

Clearance hole for the bolt

Clearance hole medium
13.5
Clearance hole fine
13

Clearance hole to ISO 273 for the bolt you tighten with this nut.

In your BOM

One notation per nut

Use the designation from the standard itself (standard, size, property class) and keep that notation throughout the BOM. For example:

ISO 4032 - M12 - 8

Common mistake: ISO4032 M12, ISO 4032 - M12 - 8 and Nut M12 are three lines in the BOM, while they are one part.

Matching bolt

Bolts for the M12

Match the property class of the nut to the bolt: an 8.8 bolt takes a class 8 nut, a higher class is fine as well. For stainless steel, for example A2-70.

Questions

Frequently asked questions about the M12

01 Which spanner fits an M12 hex nut?

A 18 mm spanner (ISO 4032). For a nut to the old DIN 934 the width across flats is 19 mm.

02 How high is an M12 hex nut?

At most 10.8 mm to ISO 4032. A nut to the old DIN 934 is at most 10 mm high.

03 Which nut goes with an M12 8.8 bolt?

An M12 nut of property class 8, for example ISO 4032 - M12 - 8. A higher class is fine as well, a lower one is not.

04 How do I put an M12 hex nut in my BOM?

With standard, size and property class, for example ISO 4032 - M12 - 8. Use the same notation everywhere. If an older drawing still says DIN 934, choose deliberately: from M5 the ISO nut is higher, and for M10 and M12 the width across flats differs too.

Checked against

Every dimension on this page was checked on 15 November 2026 against at least two of these sources.

For a critical application, always check the dimensions in the standard or with your supplier.

Is this nut in your BOM twice?

Put model, drawing and BOM side by side and see per position what doesn't match.