Standard part · ISO 4032
Hex nut M3 ISO 4032 / DIN 934
All dimensions of the M3 hex nut: width across flats and height per ISO 4032 and DIN 934, the clearance hole for the bolt and which bolt goes with it. And how to put it in your BOM so it is not ordered twice.
Dimensions
M3 in mm
- Thread
- M3 × 0.5
- Width across flats s (ISO)
- 5.5
- Width across flats DIN 934
- 5.5
- Height m (ISO)
- 2.4
- Height DIN 934
- 2.4
m is the maximum height. DIN 934 is withdrawn; its dimensions are listed because you still find them in older BOMs.
Holes
Clearance hole for the bolt
- Clearance hole medium
- 3.4
- Clearance hole fine
- 3.2
Clearance hole to ISO 273 for the bolt you tighten with this nut.
In your BOM
One notation per nut
Use the designation from the standard itself (standard, size, property class) and keep that notation throughout the BOM. For example:
ISO 4032 - M3 - 8
Common mistake: DIN 934 M3, ISO 4032 - M3 - 8 and Nut M3 are three lines in the BOM, while they are one part.
Matching bolt
Bolts for the M3
Match the property class of the nut to the bolt: an 8.8 bolt takes a class 8 nut, a higher class is fine as well. For stainless steel, for example A2-70.
Questions
Frequently asked questions about the M3
01 Which spanner fits an M3 hex nut?
A 5.5 mm spanner (ISO 4032). For a nut to the old DIN 934 the width across flats is 5.5 mm.
02 How high is an M3 hex nut?
At most 2.4 mm to ISO 4032. A nut to the old DIN 934 is at most 2.4 mm high.
03 Which nut goes with an M3 8.8 bolt?
An M3 nut of property class 8, for example ISO 4032 - M3 - 8. A higher class is fine as well, a lower one is not.
04 How do I put an M3 hex nut in my BOM?
With standard, size and property class, for example ISO 4032 - M3 - 8. Use the same notation everywhere. If an older drawing still says DIN 934, choose deliberately: from M5 the ISO nut is higher, and for M10 and M12 the width across flats differs too.
Checked against
- ISO 4032:2023, tabel 1 en 2 (inkijkexemplaar)
- ISO 4032:1999, tabel 1 (inkijkexemplaar)
- Reyher: Technische Informationen (ISO 4032 ersetzt DIN 934)
- KIPP: Sechskantmuttern DIN 934 / ISO 4032 (datasheet)
- BOLTS: DIN 934
- neue-physik.de: Durchgangslöcher (DIN EN 20273)
- Albany County Fasteners: clearance holes ISO 273
Every dimension on this page was checked on 15 November 2026 against at least two of these sources.
For a critical application, always check the dimensions in the standard or with your supplier.
Is this nut in your BOM twice?
Put model, drawing and BOM side by side and see per position what doesn't match.