Skip to content
BOMproof

Standard part · ISO 4032

Hex nut M6 ISO 4032 / DIN 934

All dimensions of the M6 hex nut: width across flats and height per ISO 4032 and DIN 934, the clearance hole for the bolt and which bolt goes with it. And how to put it in your BOM so it is not ordered twice.

s 10m 5.2M6

Dimensions

M6 in mm

Thread
M6 × 1
Width across flats s (ISO)
10
Width across flats DIN 934
10
Height m (ISO)
5.2
Height DIN 934
5

m is the maximum height. DIN 934 is withdrawn; its dimensions are listed because you still find them in older BOMs.

Note: the DIN 934 nut M6 is 5 mm high, the ISO 4032 nut 5.2 mm. The spanner is the same, but they are two different items. Pick one in your BOM.

Holes

Clearance hole for the bolt

Clearance hole medium
6.6
Clearance hole fine
6.4

Clearance hole to ISO 273 for the bolt you tighten with this nut.

In your BOM

One notation per nut

Use the designation from the standard itself (standard, size, property class) and keep that notation throughout the BOM. For example:

ISO 4032 - M6 - 8

Common mistake: ISO4032 M6, ISO 4032 - M6 - 8 and Nut M6 are three lines in the BOM, while they are one part.

Matching bolt

Bolts for the M6

Match the property class of the nut to the bolt: an 8.8 bolt takes a class 8 nut, a higher class is fine as well. For stainless steel, for example A2-70.

Questions

Frequently asked questions about the M6

01 Which spanner fits an M6 hex nut?

A 10 mm spanner (ISO 4032). For a nut to the old DIN 934 the width across flats is 10 mm.

02 How high is an M6 hex nut?

At most 5.2 mm to ISO 4032. A nut to the old DIN 934 is at most 5 mm high.

03 Which nut goes with an M6 8.8 bolt?

An M6 nut of property class 8, for example ISO 4032 - M6 - 8. A higher class is fine as well, a lower one is not.

04 How do I put an M6 hex nut in my BOM?

With standard, size and property class, for example ISO 4032 - M6 - 8. Use the same notation everywhere. If an older drawing still says DIN 934, choose deliberately: from M5 the ISO nut is higher, and for M10 and M12 the width across flats differs too.

Checked against

Every dimension on this page was checked on 15 November 2026 against at least two of these sources.

For a critical application, always check the dimensions in the standard or with your supplier.

Is this nut in your BOM twice?

Put model, drawing and BOM side by side and see per position what doesn't match.